This is the 7th month of the worldwind Cheesepalooza challenge. February is getting down with washed curds.  This month we were asked to make a Havarti, Edam, Fontina or Gouda. I opted for the Dutch creamy and buttery Gouda cheese.

gouda 12

If you want to see the whole process of making cheese, from flocculation to cutting the curd and releasing the whey, check out my earlier post. What sets this recipe apart is the washed curds technique. Once the curd has been cut there are a few techniques that allow you to get as much whey out of the curds. One way is to drain part of the whey, then add hot water to raise the temperature of the curds to a specified degree. Here we do this twice in a row, elevating the temperature again on the second wash.

gouda 06
gouda 07
gouda 08

The brine recipe I got here. Once you are done brinning just put the brine in a thick freezer zip-lock bag and keep it in the freezer till you need it again. Keep in mind the liquid will not become soild so make use it is place somewhere it will stay upright.

gouda 10

This Gouda was inspired by this recipe but I modified the last bit. There are lots of conflicting opinions when it comes to the drying and aging part. I opted for a shorter drying time of 7 days instead of 21. I think the later is too much and would make the cheese to dry. I waxed it at 7 days and it has now been aging in the fridge for 1 month.

gouda 03
gouda 04



Home Cheese Making by Ricki Carroll
Course Cheese and Dairy
Servings 1


  • 1 gallon whole milk
  • 2 ounces mesophilic starter culture
  • 1/4 teaspoon calcium chloride diluted in 1/4 cup cool water
  • 1/4 teaspoon liquid rennet diluted in 1/4 cup cool water
  • 1/2 gallon water
  • 1 pounds cheese salt
  • 1/2 tablespoon calcium chloride
  • 1/2 teaspoon vinegar


  • Heat the milk to 90 degrees. Add the culture and mix well. Cover and allow the milk to ripen for 10 minutes.
  • Add diluted calcium chloride and mix for 30 seconds.
  • Add the diluted rennet and stir gently with an up-and-down motion for 1 minute.
  • Cover and let the milk set at 90 degrees for 1 hour, or until the curds give a clean break.
  • Toward the end of the hour, start heating your pot of water.
  • Cut the curd into 1/2-inch cubes. Let them set for 10 minutes.
  • Drain off one-third of the whey.
  • Stirring continuously, slowly add just enough 175 degree water to raise the temperature of the curd to 92 degrees.
  • Let the curd settle again for 10 minutes. Drain off the whey to the level of the curd.
  • Once again, while stirring constantly, slowly add just enough 175 degree water to bring the temperature of the curd to 100 degrees. Keep the curd at 100 degrees for 15 minutes, stirring often to keep the curds from matting.
  • Allow the curds to set for 30 minutes. Pour off remaining whey.
  • Quickly place the warm curds in a 1-pound cheese mold lined with cheesecloth, breaking them as little as possible. Press at 20 pounds of pressure for 20 minutes.
  • Remove the cheese from the mold and gently peel away the cheesecloth. Turn over the cheese, re-dress it, and press at 40 pounds of pressure for 20 minutes.
  • Repeat the process (turn over the cheese, re-dress it) but press at 50 pounds of pressure for 8 hours. Remove from the press delicately.
  • Make a brine using 1 pound of cheese salt stired until disolved. Mix in calcium chloride and vinegar.
  • Soak the cheese in the brine in the refrigerator, 3 hours per pound of cheese. Flip it every 45 minutes. Remove the cheese from the brine and pat dry.
  • Air dry in the fridge on a matt for 7 days.
  • Wax the cheese. Age it at 50 degrees for 3-4 months, turning it 3 or 4 times a week.


gouda 13

What do you do when a cheese recipe says to age your cheese in a cheese cave at say 50 F with an 80% humidity index….but without the cheese cave? Get an air tight container, put a couple of chopsticks on the bottom, place your cheese on top so air can pass underneath it. The cheese should take about 40% of the space. Ball up a wet paper towel in the opposite corner of the container. Keep an eye on the humidity level with a hygrometer. If you are air drying a cheese and it starts to crack you can place it in this type of container for a few days: by equalizing the humidity inside and out the cracks will heal.

gouda 11

I’ll be out for next month’s challenge but will be back in 2 months for Brie or Camembert!

If you want to learn more about cheese making check out my past posts on